![]() ![]() Your own network is probably different, like 192.168.0.1/24. ![]() For my network, the network ID and subnet mask is 10.0.100.1/24. I'm telling it to look for any devices with IP addresses in the same range as my main network. In this command, I'm calling the nmap utility, which is a utility used for Network Mapping. ![]() Once booted, assuming you have the Turing Pi plugged into your network, you can go to another Mac or Linux computer on the same network and run the following command: nmap -sn 10.0.100.1/24 | grep 'turing\|worker' Usually, you'll know the Pis are booted when the red activity LED next to each board is mostly 'off' instead of 'on'. The first boot can take a while, because Hypriot or even Raspbian has to do a bit of housekeeping the first time it boots up. It also helps me associate the Pi's IP addresses with their hostnames, which may come in handy later.Īfter you plug in the Turing Pi, you have to wait a few minutes for all the Pis to fully boot. I didn't just do that for fun it helps me find them on my network, when I boot them up and plug the Turing Pi into the network. ![]() When I flashed all the Compute Modules with Hypriot OS, I set a unique hostname for each Pi, like master, worker-01, and worker-02. In this episode, I'm going to show you how to find and connect to all the Raspberry Pis, then how to install Kubernetes on the Turing Pi cluster. In the second episode, I spoke about how to put everything together in a Turing Pi cluster and get the Raspberry Pi Compute Modules ready to boot. In the first episode, I talked about how and why I build Raspberry Pi clusters like the Raspberry Pi Dramble. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |